GS-METAL

News

Home > News

Titanium Alloy Size Regulations

Jan. 01, 2020

The scale of titanium is one of the basic knowledge of titanium. The scale of titanium generally refers to the length of titanium. The length of titanium mainly includes length, width, height, diameter, radius, inner diameter, outer diameter, wall thickness and so on. Units of titanium material length are meters (m), centimeters (cm), millimeters (mm) and so on. To know them, they need to understand titanium materials. Titanium materials include titanium rods, titanium plates, titanium tubes, titanium wires, etc. They are rolled from titanium and titanium alloys. The Titanium Alloy Bar Factory will introduce the size regulations of titanium rods, plates, tubes and wires in detail.


1. Scale of titanium

It is a useful way to save data. The scale is the length or length by width not less than a certain size, or the length of the titanium plate. Delivered within the scale scale from length to width. The producing unit can produce and supply according to the demand of this scale.


2. Indeterminate

Refers to the general length. Where the product scale (length or width) is within the standard scale, but does not require a fixed scale, it is called an indefinite ruler. Indeterminate length is also known as general length (through rule). Metal materials delivered to an indefinite length can be delivered within a regular length. For example, for general round titanium with a length of not more than 25mm, the general length rule is 4-10m, so round titanium with a length within this scale can be delivered.


3. Sizing

Cut to a fixed size according to ordering requirements is called fixed length. When delivering at a fixed length, it is necessary for the metal materials to be delivered with the length specified by the purchaser in the order contract. For example, it is stated in the contract that the delivery will be 5m in fixed length. The delivered information must be 5m in length, and less than 5m or good at 5m is unqualified. However, in practice, delivery cannot be all 5m long, so the rule promises positive errors instead of negative errors.


4. Ruler

Cut into whole multiples according to the fixed scale of the order demand is called a double ruler. When delivering at the multi-foot length, the length of the metal data submitted must be an integer multiple of the length specified by the purchaser in the order contract (called a single foot) (plus a sawn). For example, the buyer needs a single ruler with a length of 2m in the order contract. Then, the length is 4m when cut into double rulers, and 6m when cut into 3 times rulers. . The sawing volume has rules in the specification. When delivering at multiple scales, only a positive error is allowed, and a negative bias value is not allowed.


5. Narrow ruler

The width is less than the lower limit of the indefinite rule width of the standard rule, but it is not smaller than the narrowest width that is promised. When delivering on narrow gauges, it is necessary to pay attention to the narrow gauge share and the narrowest gauge of the relevant rules and regulations.


Titanium Tubing


Titanium Tubing


6. Ruler

The length is less than the lower limit of the indefinite ruler length of the Titanium Tubing specification, but it is not less than the shortest length agreed. For example, the rules in the specification of titanium pipes for water and gas transportation promise that each batch has 10% (calculated according to the number) of 2-4m long titanium pipes. 4m is the lower limit of the indefinite length, and the minimum length agreed is 2m.


The above are the dimensions of titanium rods, plates, tubes and wires introduced by Titanium Wire supplier. Have you learned?

Previous: Classification And Development Of Titanium Wire

Next: The Main Application Fields Of Titanium Alloy Materials

hot products

WeChat

Whatsapp

Skype

E-mail